R105 Skid Loader


The R105 is built for efficiency. Super Hi-Power drive chains feature heavy, high-strength construction designed for the most rugged conditions.

Longer wheelbase and a low center-of-gravity offer a smooth, stable ride.
Hydraloc™ automatic interlock system locks lift, tilt and drive systems when the operator leaves the seat, increasing operator safety. System also engages when the restraint bar is raised or the ignition switch is turned off.
Lift arm hydraulic tubes are concealed and protected from the work environment.
Rated operating load can be readily increased with the addition of a counterweight.

Overall Width (mm) 48.4″ (1229)
Overall Height to Top of ROPS (mm) 70.3″ (1786)
Specification Sheet


A Overall Operating Height – Fully Raised 139.6″
B Height to Hinge Pin – Fully Raised 108.1″
C Overall Height to Top of ROPS 70.3″
D Overall Length with Bucket 114″
E Dump Angle at Full Height 42°
F Dump Height 84.5″
G Dump Reach at Full Height 22.8″
J Rollback at Ground 29°
M Rollback Angle at Full Height 99°
O Seat to Ground Height 32.6″
P Wheelbase 34.5″
Q Overall Width – Less Bucket A 48.4″
R Bucket Width 55″
S Ground Clearance to Chassis 6.0″
V Overall Length – Less Bucket 88.9″
W Departure Angle 26°
X Clearance Circle – Front w/ Bucket 69.4″
Y Clearance Circle – Front w/o Bucket 44.1″
Z Clearance Circle – Rear 54.1″
Standard Specification Tire Size 27×8.5×15 HD
Make Yanmar
Model 3TNV88C-KMS
Tier IV
Gross Power @ 2500 rpm 25.5 hp
Net Power @ 2500 rpm 24.7 hp
Maximum Torque 80 ft.-lbs. @ 1680
Displacement 100 cu.in.
Hydraulic System
Auxiliary Hydraulics – Standard 14.5 gpm
High-Flow Auxiliary Hydraulics – Option N/A
Reservoir Capacity 8 gal.
Electrical System
Battery 12-volt
Starter 12-volt
Alternator 40-amp
Rated Operating CapacityB 1,050 lbs.
Rated Operating Capacity with Optional CounterweightB 1,175 lbs.
Fuel Tank 10.4 gal.
Travel Speed – Maximum 5.9 mph
Travel Speed with Two-Speed Option – Maximum N/A
Operating WeightC – Approximate 4,000 lbs.

A – Overall width is dependent upon the amount of wheel offset.

B – Per SAE J818, SAE J732, and ISO 14397

C – Weight of base unit with standard equipment, standard tires (heavy-duty flotation), standard dirt-construction bucket and 79 kg operator.